XIFORLAI, an industrial washing machine equipment manufacturer, analyzes the causes and treatment methods of wrinkles in chemical fiber fabrics washed by industrial washing machines.
There are generally three reasons for wrinkles in industrial washing machines after washing chemical fiber fabrics:
1. The industrial washing machine suddenly loses power, water or equipment failure during the washing process;
2. The washing temperature of the industrial washing machine is too high or fails to cool gradually during the water flow;
3. The industrial washing machine has too much washing load or the drying temperature is too high and no air cooling is performed.
So how should we solve the above problems? XIFORLAI summarizes the following methods for everyone:
1. In the main washing stage of the industrial washing equipment, if there is a water or power outage, delayed washing should be carried out immediately to ensure normal water supply before continuing normal operations.
2. In the main washing stage of the industrial washing equipment, if there is a power outage for about 10 to 20 minutes, the main washing temperature should be adjusted to 10°C higher than the temperature for main washing when the power supply is normal.
3. In the event of a malfunction of the industrial washing equipment, the engineering department should be notified immediately for maintenance, such as: equipment drainage system failure. After the mechanical maintenance is normal, the second method should be used.
4. If the temperature is too high during the main washing of the industrial washing equipment, the first water inlet should be delayed during the water flow and gradually cooled.
5. Before washing the industrial washing equipment, the equipment and washing procedures must be followed. When drying, the machine operator is strictly prohibited from stacking to avoid wrinkles.
6. When wrinkles are found in the fabric, remedial measures should be taken immediately.
The above is the introduction to the causes and treatment methods of wrinkles in chemical fiber fabrics washed by industrial washing equipment. If wrinkles occur when you use industrial washing equipment to wash chemical fiber fabrics, you can refer to the above method to find the cause and then solve it.